Home > Ducati > 848 > 2008 - 2012 >

All Years Ducati 848 / 1098 / 1198 R / S / SP No Cut Frame Front & Rear Quick Release Axle Sliders

T-Rex Racing All Years Ducati 848 / 1098 / 1198 R / S / SP No Cut Frame Front & Rear Quick Release Axle Sliders


 
Alternative Views:


Part Number: N80-7 + N80-7F + N80-7RQL
Our Price: $229.95


Availability:: Usually Ships in 24 to 48 Hours


Kit Color:


Qty:  
Description
 
  • Condition: New
  • Material: UHMW-PE (ultra high molecular weight polyethylene), steel, aircraft grade aluminum, High Strength Neodymium Magnets
  • Slider dimensions: Approx. 2.5" and 3.5" in length and 2" in diameter for the frame sliders,1.5" in overall length, 1.75" in diameter for the front axle sliders, 4" in overall length, 2" in diameter for the rear axle sliders.
  • No cut or plastic fairing modifications required
  • Fit Models: Ducati
  • All Years 848 / 1098 / 1198 R / S / SP
This purchase is for a pair of frame sliders, front axle sliders, and rear quick release axle sliders. The frame slider features a new design of a complete solid puck without a hollowed-out center. This increases the strength and contact surface to about 30%. The spacer is bolted to the engine mount and the slider puck is screwed onto it. Since this spacer is made of solid billet aluminum there is no need for re-tightening the engine bolt in the long run where you have to do so with a plastic slider as the plastic would gradually give in and therefore making the bolt loose. The front part of the frame slider kit features the under fairing frame slider which like it is stated sits behind the faring. It protects the fairing bracket and other critical engine components.The quick release rear sliders allow one to quickly remove the rear sliders without removing any bolts or screws like those in a typical rear axle slider. It facilitates quick removal of the rear wheel, an essential convenience at the track. You can promptly raise your bike as soon as you pill in a paddock. The two sides of the rear axle sliders are attached by high strength Neodymium magnets. The puck material is made of UHMW-PE (ultra high molecular weight polyethylene), a tough plastic with good strength, wear resistance and dimensional stability. It is more dimensionally stable than Nylon and used in many industrial ball bearing and friction reducing applications. Compared to Delrin, it is softer but tougher. Delrin is harder but more brittle. It is an ideal material for slider since it can absorb more impact force onto itself and therefore reduce the impact on the frame and engine. The slider pucks can be inexpensively replaced in case of a low-side. The bolts are made of grade 6 stainless steel. We use highest grade commercially available 12.9(177,000 psi in tensile strength) wherever possible. Rest assured that you are getting the best material commercially available.



Share your knowledge of this product. Be the first to write a review »