Home > Shop > Frame Sliders > Kawasaki > ZX6 / ZX6R / ZX10R / ZX14 / ZX14R / ZZR600 / ZZR1400 >

2013 - 2015 Kawasaki ZX-6R No Cut Frame Front & Rear Axle Sliders Spools

2013 - 2015 Kawasaki ZX-6R No Cut Frame Front & Rear Axle Sliders Spools


 
Alternative Views:


Part Number: N52-13A + N52-13F + N56-11R + BlaPlaSpool8
Our Price: $159.95

Quantity in Stock:(Out of Stock)

Availability:: Usually Ships in 24 to 48 Hours
Qty:

Description
 
  • Condition: New
  • Special feature: The pucks are solid and not hollow, made to withstand a greater impact
  • Material: UHMW-PE (ultra high molecular weight polyethylene), aircraft grade aluminum spacers
  • Slider dimensions: approx. 2.5 " in length, 2" in diameter
  • No cut or plastic fairing modifications required
  • Fit models: Kawasaki
  • 2013 - 2015 Ninja ZX6R 636
This purchase is for a set of frame sliders, front axle sliders, and rear axle sliders for the models above. The sliders feature the new design of a complete solid puck without a hollowed-out center. This increases the strength and contact surface to about 30%. The sliders (black) spacer is machined from 6061-T6 aluminum. The spacer is bolted to the engine mount and the slider puck is screwed onto it. Since this spacer is made of solid billet aluminum there is no need for re-tightening the engine bolt in the long run where you have to do so with plastic slider as the plastic would gradually give in and therefore making the bolt loose. The puck material are made of UHMW-PE (ultra high molecular weight polyethylene), a tough plastic with good strength, wear resistance and dimensional stability. It is more dimensionally stable than Nylon and used in many industrial ball bearing and friction reducing applications. Compared to Delrin, it is softer but tougher. Delrin is harder but more brittle. It is an ideal material for slider since it can absorb more impact force onto itself and therefore reduce the impact on the frame and engine. The slider pucks can be inexpensively replaced in case of a low-side. For the front axle sliders the installation is a simple bolt on with the bar going through the axle and one plastic puck on each side. The long bar is made of billet aluminum. We use highest grade commercially available 12.9(177,000 psi in tensile strength) wherever possible. Rest assured that you are getting the best material commercially available.

Share your knowledge of this product. Be the first to write a review »