Home > Shop > Lowering Links > Kawasaki > Versys 650 / 1000 >

2015 - 2023 Kawasaki Versys 650 / ABS / LT Lowering Link

T-Rex Racing 2015 - 2020 Kawasaki Versys 650 / ABS / LT Lowering Link


 
Alternative Views:


Part Number: LL54-15
Our Price: $99.95

Quantity in Stock:20


Availability:: Usually Ships in 24 to 48 Hours
Qty:

Description
 
  • Condition: New
  • Material: Aircraft grade aluminum
  • Fit Models: Kawasaki
  • 2015 - 2023 Versys 650
  • PDF Instruction:
This purchase is for a lowering link that can lower your bike by approximately 2". Getting a lowering link? Check out our adjustable kickstands that can be lowered from stock length to approximately 2" shorter. No need to modify your existing kickstand!

Average Rating: Average Rating: 4 of 5 4 of 5 Total Reviews: 3 Write a review »

  1 of 1 people found the following review helpful:
 
4 of 5 Lowering link October 1, 2023
Reviewer: Alex from Missouri  
Well made kit and high quality hardware. Instructions could be better but I was able to figure it out.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
4 of 5 Overall a nice kit, don't forget the side stand! June 3, 2023
Reviewer: Steve from Wyoming  
This was super simple to install, took about an hour in my driveway. I did admittedly install the luggage guards first and used that to unload the pressure from the spring using a pair of bottle jacks and some creative "cribbing" (I used a set of automotive ramps to get closer to the height I needed). When using bottle jacks from below, don't forget to leave yourself some room to completely lower the bike back onto the stands/swing arm support. This is the second bike I've lowered and both times I made the mistake of setting my jack too tight and had to fight to get it lowered to the ground.
The instructions for relocating the adjustment knob are not great! I had previously lowered the front of my bike about an inch but will have to go down a bit more to get it leveled out. The ride was super harsh after install and ground clearance is greatly reduced.

Was this review helpful to you?

  2 of 2 people found the following review helpful:
 
4 of 5 Overall a Nice Drop August 12, 2022
Reviewer: Wayne K from Liberty, SC  
Installed this on my 2019 Versys 650 and it lowers the bike about 1-1/4". You'll need to support the bike from above with something like an automotive engine hoist (cherry picker). I've read some folks use jacks creatively, but whatever you use to get the weight off the rear spring you can then remove the bolt & install the lowering block. The block seems to need a little finessing to install but it works. There's also a bracket in the kit for relocating the factory adjustment knob.Then the front just needs supported to remove the bike weight from the forks while you loosen all the clamping bolts. Once loosened just lower the front end thru the forks about 1-1/4" or so (I measured both from the top of each fork so they are exactly equal to each other). Tighten all the clamping bolts back up, lower the bike fully down and you'll notice the side stand is now too long. Hopefully you bought the adjustable side. 4-Stars

Was this review helpful to you?